4313_Level_12in.jpg

DIY Window Installation Troubleshooting in Roanoke, Virginia

Published on

Your satisfaction with your Pella windows and doors is our top priority. Should you have a problem with your Pella product that you believe could be related to the window’s installation, trying the following steps may help determine if the product is installed level, square and plumb.

First, get a level and put it on the frame of the product, across the bottom or sill. Do not set it on the sashes or panels of the product since it could give an inaccurate reading. The bubble of your level should settle in the center, indicating the product is installed level.

Next, test plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To check for plumb, set your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. Next, you’ll check for plumb from left to right by placing the level on each side. The bubble should fall in the midpoint on both sides, indicating the product is installed plumb.

After checking plumb, you can look for bowing by measuring the unit horizontally across the top, middle and bottom. The measurements of these three places should all be equal, allowing 1/8 inch of leeway. It’s critical to always measure to and from the same point on both sides for consistency. Finally, determind if your window or door is square by measuring from corner to corner in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other to indicate the product is installed square.

You may also examine the reveal, where the sash meets the frame. The gap should look the same from top to bottom and left to right. Every side of your product should appear the same, demonstrating the product is installed level, square, and plumb.

Taking the time to do a little troubleshooting on your own can provide helpful information to fix a problem. If you find that you have stumbled upon one, or even a couple, of these issues, stop by the Pella Window and Door Showroom in Roanoke or give us a call at 540-466-1918.